EP30006
ORDER NO.HPD0706U16C1
- 39 -
10.15.3. Removing the Intensity sensor
1. Disconnect the Connectors on the Main PCB.
2. Cut two Insulated ties.
3. Unscrew one Screw.
Caution in assembly
- Put the swell parts of the Massage mechanism block frame to the hollow parts of the Intensity sensor. (Otherwise, it
may lead to the overrun in the direction of stronger.)
- When fixing the Lead wires with Insulated ties, move the Massage mechanism block in the directions of strong-weak
so as to check whether the Lead wires are pulled or hooked.
To Next Page
Loading...
