Panasonic EX-10 Series - 3 Mounting; Mounting of the Sensor

6
3.
Mounting
3-1 Mounting of the sensor
● The tightening torque should be 0.2 N·m or less.
● The narrow beam type EX-1□S□ emits a narrow light beam, so it is difcult to align the beam.
Note that if screws or other parts become loose due to vibration, for example, the beam axis may
drift.
● In case of mounting on tapped holes (Unit: mm)
● In case of using attached screws and nuts (Unit: mm)
● In case of using mounting bracket (optional)
The sensor bracket is an object for satandard-beam type. It cannot be used for narrow-
beam type.
11
11
11
11
MS-EX-10-2
MS-EX-10-3
MS-EX-10-1
MS-EX-10-11 MS-EX-10-12
MS-EX-10-13
Side sensingFront sensing
M2 × 0.4
tapped, 7 deep
Sensing
direction
M2 screw
[length 8
(accessory) ]
Sensing
direction
M2 × 0.4
tapped, 6 deep
Thickness of mounting
plate: 2.5 or less
Flat washers
(accessory)
Nuts
(accessory)
Spring washers
(accessory)
Front sensing
Sensing
direction
M2 screw
[length 8 (accessory) ]
Side sensing
Thickness of mounting
plate: 2 or less
Flat washers
(accessory)
Nuts
(accessory)
Spring washers
(accessory)
Sensing
direction
Material: SPCC (Uni-chrome plated)
Two M2 (length 4 mm) pan
head screws (Accessory)
Material: SPCC (Uni-chrome plated)
Two M2 (length 8 mm) pan
head screws (Accessory)
Material: SPCC (Uni-chrome plated)
Two M2 (length 4 mm) pan head screws
Two M2 (length 8 mm) pan head screws
Accessory: 2 pan head screws each
Material: SUS304
Two M2 (length 4 mm) pan
head screws (Accessory)
Material: SUS304
Two M2 (length 8 mm) pan
head screws (Accessory)
Material: SUS304
Two M2 (length 4 mm) pan head screws SUS304
Two M2 (length 8 mm) pan head screws SUS304
Accessory: 2 pan head screws each
M2 screw
[length 10
(accessory) ]
M2 screw
[length 10
(accessory) ]
info@digiparts.ch
www.digiparts.ch
Ihr Schweizer Industriepartner