3. Verify
Tool In
Calibration
Lab
4. Run
Tool On
Application
5. Verify
Tool On
Application
6. Update
Worksheet
1. Look Up
Application
Settings On
Worksheet
2. SetUp
Tool
Reinstate Mechanical Pulse Tools On Applications
Following these guidelines, including the “Set Up Worksheet”, will streamline the
set up and verification process.
Set Up
Worksheet
Static/Residual
Torque Audit
w/ Audit Wrench
Method For
Reinstating Tools
*In most cases, Residual (Audit Wrench) & Dynamic (Transducer)
torques will be different due to differences in the joint!
Set Up
Worksheet
To Next Page
Loading...
