44
Care and maintenance
(continued)
●
Do not use the detergents or other
substances on the right.
●
You can use the oxygen-based bleaching
agent only when cleaning the humidifying filter.
●When using chemically treated cloth, follow
its instructions.
Before cleaning
■Besuretodisconnectthepowerplug.
*1
Asthedirtinessvariesdependingonthewaterquality,maintenancemayberequiredevenwithinonemonthafter
the last maintenance. If it smells unpleasant or water in the tank decreases less than before, clean the tank.
Body, Front panel <about once a month>
Anti-fungus assembly <about once a month*
1
>
Tank <every day>
Tray
<about once a month*
1
>
Wipe with a soft wrung cloth.
(Installationandremoval→P.36)
Wiping with hard cloth may scratch the surface.
●Wipe the power plug with dry cloth.
Soaking.
●
See“Toremovethestubbornstains”.
●Do not scrub with a brush or disassemble
the anti-fungus assembly.
●Install it into the tray groove so that it is level.
Note
●The anti-fungus assembly may have powder.
This is normal and it performs without problem.
●The anti-fungus agent will become smaller over time.
This is normal and it performs without problem.
●The anti-fungus agent has a peculiar smell. It is not harmful.
Remove the anti-
fungus assembly,
wash with water.
●
Wipe the dirt in details with
cotton swab or toothbrush.
●Do not remove the floater
(polystyrene foam).
→Ifitcomesoff(P.46)
●Stubborn stains
→See“Toremovethe
stubbornstains”.
Wash with water.
●
Stubborn stains
→See“Toremovethe
stubbornstains”.
Tank / Tray /
Anti-fungus assembly
Front panel
Floater
Anti-fungus assembly
Humidifyinglterset
●Remove the tank,
and pull out the tray.
●Thefilterhasa“thick”and“thin”shaft.
Take care when installing it on the tray.
Shaft: thin
Shaft (rear): thick
Shaft mount:
thick
Shift mount: thin
●Remove while
pressing the tab.
Tab
Anti-fungus
assembly
Tray