Please put back the remote control to the holder.
Install two R03(AAA) Carbon batteries in the remote control.
Do not short circuit.
Please observe the following when using the batteries.
將2粒R03(AAA)碳性電池放入遙控器中。
將遙控器放回遙控器底座。
電池的使用請遵守以下內容。
勿將電池正負反裝。
勿將新舊、異種電池混合使用。
長期不使用時，請取出電池。
更換電池時，請擦乾遙控器機體後進行更換。
不可短路。
(否則可能會導致漏液或破損)。
警告
WARNING
Do not inversely install the positive
pole and negative pole of batteries.
Do not use an old battery together
with a new battery or use different
types of batteries in a mixed way.
(Otherwise, aleakage or damagemaybecaused.)
2.Do not replace the batteries when the remote control body is wet.
1.lf you will not use the remote control for a period of time, take out the batteries.
3.Do not exert too hard when you rotate the" " knob on the remote control back,
otherwise the knob will be damaged.
旋動遙控器背部 字旋鈕時，請勿用力過大，否則可能會損壞該旋鈕。
14
5.Please don't install remote control and product in the same plane, otherwise,
it may cause product out of control.
請勿將遙控器與產品安裝於同一平面，否則可能會導致無法遙控產品。
請勿將遙控器浸入水中。
拿取遙控器時請小心，以免遙控器掉落導致損壞。
4.Please be careful with picking up remote control, to avoid dropping and cause damage.
丟棄電池時，請遵循當地法律法規。
Please comply with local laws and regulations when disposing the battery.
6.Please don't immerge the remote control into water.
提示事項
Notice
安裝方法
HOW TO INSTALL
供安装人员阅读
將旋鈕 向左轉至
“ ”位置
Rotate the knob “ “
leftward to the “ ”
position.
[關]的狀態
[Close] status
[開]的狀態
[Open]status
打開電池蓋。
Install two R03(AAA) Carbon
batteries in the remote control.
(Pay attention to the directions of
“ ” and “ ”)
將兩粒R03(AAA)碳性電 池放入遙 控
器中。(注 意 ， 方向)
Replace the battery cover.
重新蓋 上電池蓋 。
將旋鈕 向右轉至“ ”位置。
Rotate the knob “ ” rightward to
the “ ”position.
旋鈕
knob
To Next Page