膠塞( 6×26 mm)(另購 )
36 mm
自攻螺 絲( 4× 16 mm)
2
-
6
深
28 mm
2
-
6
28 mm
13
在浴室的牆壁上開2顆 6的安裝孔，將遙控器
底座安裝於牆上。
Open two 6 holes in the bathroom wall
as shown below. And install the controller
holder.
Install the filter.
Fix the louver assembly onto the
main body with the supplied one
M4×10 machine screws.
M4×10
machine
screws.
使用附件包所提供的1顆M4×10的機
械螺絲，將面板組合固定於機體。
機械螺絲
M4×10
裝上過濾網。
Take out the remote control from the
holder.
遙控器的安裝
把遙控器從遙控器底座抽出。
5.Installing the remote control
Check the main body can receive the signal
from the intended remote control installation
location. If remote control can not receive the
signal from this installation location, please
choose another installation location, or operate
the remote control toward product after taking
out it from the holder. The installation location
cannot be toward the direct spraying area of the
shower.
遙控器安裝前，請在預定安裝的位置上檢測機體接
收信號的效果，若該位置無法使機體正常接收，請
另選擇合適的位置或使用時把遙控器從底座中取出
對著機體進行操作。且安裝位置應避免在花灑直淋處。
安裝方法
HOW TO INSTALL
底座
Holder
Pull up
遙控器
向上拔出
Remote
control
7
8
Recover the screw cap.
重新蓋上螺絲蓋。
Plastic plug( 6 x 26 mm)
(please purchase it separately)
Self-tapping screw
( 4 x 16 mm)
Filter
過濾網
To Next Page