5. Attach the buckles (E), and adjust the buckle belts so that the hand strap is not loose (F).
• Insert the buckles until you hear a click.
6. Open the cover, adjust the hand strap to fit your hand, fold back and fasten the belt, and then fold the
cover.
• Make sure that the ring does not go past the stopper (G). If it does, the belt may get detached from
the ring and the unit may fall.
Replacing the battery
To replace the battery, detach the buckles.
Attaching the shoulder strap
After step 3 above, attach the shoulder strap to the rings of the hand strap.
• You can hang the unit horizontally or vertically.
• Pass the strap through the rings as shown in the figure (A), pass it through the buckles (B), and then
adjust it to the desired length.
56 Operating Instructions - Reference Manual
Supplementary items
To Next Page
Loading...
