Hand Strap (FZ-VSTS11)
Handling and maintenance
• Take care as there is a risk of the unit dropping when the hand strap is loose.
• Do not use the hand strap if it is worn out or damaged.
• Your hand, hand strap, etc. may appear in the shooting range of the camera depending on the way you
hold or the direction of the hand strap. When shooting with the camera, adjust the position of the hand
strap so that the hand strap does not enter the shooting range of the camera.
• For typical cleaning, wipe the hand strap with a soft, dry cloth.
– If the hand strap becomes dirty, wet a soft cloth with water and wring it thoroughly before wiping the
hand strap.
– Do not clean the hand strap with benzene, thinner, alcohol, household cleansers, etc., as these may
damage the hand strap.
Description of parts
A Strap storage part
B Pen holder
C Attachment part for the barcode reader
D Adjuster
You can adjust the height.
E Rings (page 56)
You can attach the shoulder strap.
Attaching
1. Rotate the belt part of the hand strap vertically (A), then detach the two buckles.
• Press the protrusions (B) of the buckle to detach it.
Operating Instructions - Reference Manual 53
Supplementary items
To Next Page
Loading...
