• Inserting the unit in the reverse direction may damage the headset terminal cover.
3. Attach the belt of the hand strap part.
• Pass the belt through the ring (G), adjust the hand strap to fit on your hand, fold back and fasten
the belt (H), and then fold the cover (I).
• Make sure that the ring does not go past the stopper (J). If it does, the belt may get detached from
the ring and the unit may fall.
4. Attach the shoulder strap.
• You can hang the unit horizontally or vertically.
• Pass the strap through the rings as shown in the figure (K), pass it through the buckles (L), and
then adjust it to the desired length.
Operating Instructions - Reference Manual 59
Supplementary items
To Next Page
Loading...
