Panasonic GT02

To Next Page

To Previous Page

4. Settings for FP7

For connecting GT series and FP7, the communication parameters of FP7 should be set with FPWIN

GR7. Execute "Option" - "FP7 Configuration" menu in FPWIN GR7, and set the parameters in the "Built-

in SCU" page.

Settings

COM0

Set when connecting the COM0 port of FP7 and GT.

COM1 settings

Set when connecting the 1CH of 1-ch or 2-ch type communication cassette

and GT.

COM2 settings

Set when connecting the 2CH of 2-ch type communication cassette and GT.

Communication

mode

Select "MEWTOCOL-7".

Unit number

Set a desired unit number. When using the PLC multiple connection, the unit

number specified by GTWIN corresponds to this unit number.

Baud rate

Set the same "Baud Rate" as that specified in GTWIN "GT Configuration" -

"Communication Parameters" - "Baud Rate".

Data length

Set the same "Data Length" as that specified in GTWIN "GT Configuration" -

"Communication Parameters" - "Data Length".

Parity

Set the same "Parity" as that specified in GTWIN "GT Configuration" -

"Communication Parameters" - "Parity".

Stop bit

Select "1".

RS/CS

Select "Disable".

Send waiting time

For connecting with RS232C or RS422, specify "0".

For connecting with RS485, adjust the setting with the GT and FP7 actually

connected.

Header STX

Select "Disable".

Modem initialization

Select "Not initialize".

Other manuals for Panasonic GT02