24
SQT0477 (ENG)
Inserting/removing an SD card
Caution:
Check that the access lamp has gone off.
1 Open the SD card slot cover and
insert (remove) the SD card into
(from) the card slot B.
≥ One SD card can be inserted into each of the
card slot 1 and the card slot 2.
≥ Face the terminal side C in the direction
shown in the illustration and press it straight
in as far as it will go.
≥ Press the center of the SD card and then pull
it straight out.
2 Securely close the SD card slot
cover.
When using a non Panasonic SD card for the first time, or one which was previously used on
another equipment, it is necessary to format the SD card. (l 29) When the SD card is formatted,
all of the recorded data is deleted. Once the data is deleted, it cannot be restored.
Access lamp A
≥ When this unit is accessing the SD card,
the access lamp lights up.
HC-X1000PP-SQT0477_mst.book 24 ページ ２０１４年９月９日 火曜日 午後１時３２分
To Next Page
Loading...
