Panasonic HDC-HS250P - Quick Guide; Battery Charging and Insertion; SD Card Insertion and Removal

12
VQT1Y31
Quick Guide
∫ Charging the battery
1 Connect the AC cable to the AC adaptor and
the AC outlet.
2 Insert the battery into the AC adaptor by
aligning the arrows.
∫ Inserting the battery
Install the battery by inserting it in the direction
shown in the figure.
A Insert the battery until it clicks and locks.
∫ Inserting/removing an SD card
1) Open the LCD monitor.
≥ Check that the access lamp has gone off.
2) Open the SD card cover by sliding the OPEN
lever B.
3) Insert/remove the SD card.
≥ Face the label side C in the direction shown in
the illustration and press it straight in as far as
it will go.
≥ Press the center of the SD card and then pull it
straight out.
4) Securely close the SD card cover.
≥ Securely close it until it clicks.
Charging lamp
[CHARGE] A
Lights up:
Charging
Goes off:
Charging
completed
Access lamp [ACCESS] A
≥ When this unit is accessing the SD card, the
access lamp lights up.
HDCHS250P-VQT1Y31_eng.book 12 ページ ２００９年１月２０日 火曜日 午前１１時１８分