46
VQT1G66
Setup
Changing the date and time display style
Press the MENU button, then select [SETUP] #
[DATE/TIME] # desired display style and press
the cursor button.
≥ You can also show or change the date and
time display by repeatedly pressing the DATE/
TIME button on the remote control.
Changing the display style
Press the MENU button, then select [SETUP] #
[DATE FORMAT] # desired display style and
press the cursor button.
≥ The date and time function are driven by a
built-in lithium battery.
≥ Make sure to check the time before recording.
≥ If the time display becomes [- -], the built-in
lithium battery has run down. Use the following
steps to charge the battery. When you turn on
the power for the first time after charging, a
message asking you to set the date and time
will appear. Select [YES] and set the date and
time.
To recharge the built-in lithium battery:
Connect the AC adaptor or attach the battery to
the unit, and the built-in lithium battery will be
recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (The battery is still
being recharged even if the mode dial is set to
OFF.)
[DATE] [D/T]
[OFF]
Display style Screen display
[Y/M/D] 2008. 1. 1
[M/D/Y] 1 1 2008
[D/M/Y] 1. 1.2008
1. 1. 2008 12:34
1. 1. 2008
WARNING
THE LITHIUM BATTERY IN THIS
EQUIPMENT MUST ONLY BE REPLACED
BY QUALIFIED PERSONNEL. WHEN
NECESSARY, CONTACT YOUR LOCAL
PANASONIC SUPPLIER.
HDC-SX5-VQT1G66_mst.book 46 ページ ２００７年７月２４日 火曜日 午後５時５６分
To Next Page
Loading...
