-9-2-
Please use drop-prevention wire and 1 pc fixing screw（M4 P0.7） to fix the wire on POS when installing
the POS on a wall.
For drop-prevention wire, please use stainless wire rope with nylon coating and its spec should afford net
weight over 5 times of the amount of POS machine (including optional module) and mounting bracket.
*POS machine’s weight is 6 kg = 13.25lbs.
Place to fix drop-prevention wire
Place for mounting bracket
.7
8mm
100 mm
100 mm
M4 P0.7
7mm
2.2. POS Installation
Please obey the attention items below.
Please install POS in places where can afford the total weight of POS machine, mounting bracket parts,
and cables.
When installing POS in counter, on table and wall, please mount the mounting bracket on the foundation
portion of a building or somewhere with sufficient strength.
※Please ensure the places to install or mount the mounting bracket & POS machine can afford for 5 times
or above of total weight of POS machine.
The weight of POS machine is 6 ㎏.
Please according to mounting places’ materials to choose fixing screw for POS mounting bracket because
based on different mounting places’ materials, the mounting method may be different. （At least 4 places.）
Steel-material wall ：use M6 or M8 bolt nut to fix.
Concrete wall ：use M6 or M8 anchor bolt to fix.
Please don’t use wooden screw or nail to fix mounting bracket because the strength is insufficient.
When installing POS on a wall, please fix POS via drop-prevention wire on the foundation portion of a
building or somewhere with sufficient strength.
Please tie the drop-prevention wire firmly.
The strength of fixing screw used on mounting bracket should be 294 N {30 ㎏ f} or above per piece.
Drop-prevention wire
(2 pieces)
Mounting Bracket
(Example)
㪮㪸㫃㫃㩷
Drop-prevention wire
(2 pieces)
Screw holes on mounting bracket (Example)
To Next Page
Loading...
