－3-11－
If test is OK, it shows mark.
If test is not OK, it shows mark.
7-1. COM1, COM2 and COM3
This is COM1 Loopback test.
You need to connect loopback connector.
Click “Test”, then PE Diag starts COM test.
7-2. USB
This is USB Write/Read test.
You need to connect writable/Readable USB devices to USB ports.
USB Memory Stick is best device.
If you connect only one USB device, select “1”. Then click “Test”.
If you connect two USB devices, select “2”. Then click “Test”.
If you connect three USB devices, select “3”. Then click “Test”.
If you connect four USB devices, select “4”. Then click “Test”.
If you connect five USB devices, select “5”. Then click “Test”.
If you connect six USB devices, select “6”. Then click “Test”.
If you connect seven USB devices, select “7”. Then click “Test”.
If you connect eight USB devices, select “8”. Then click “Test”.
7-3. LAN
This is LAN test.
You need one more JS-960Wx.
Connect LAN cable both JS-960Wx via Hub.
Write another JS-960Wx’s IP Address on the 960WSDiag_Setting.ini.
Then click “Test”.
7-4. WiFi
This is not available.
7-5. LPT
This is Pallalel Poert Loopback test.
You need to connect loopback connector.
Click “Test”, then PE Diag starts LPT test.
Loopback connector pin assignment
Loopback connector pin assignment
To Next Page
Loading...
