2. Preparation
20
2.4 Adjusting volume
Ringer volume
While the unit is idle, press {A} or {B}.
L If any documents are in the document entrance, you
cannot adjust the volume. Confirm that there are no
documents in the entrance.
To turn the ringer OFF
1. Press {B} repeatedly to display “RINGER OFF=
OK?”.
2. Press {Set}.
L When a call is received, the unit will not ring and
will display “INCOMING CALL”.
L To turn the ringer back ON, press {A}.
Ringer type
L You can select one of three ringer types (feature #17
on page 45).
Handset receiver volume
While using the handset, press {A} or {B}.
Monitor volume
While using the monitor, press {A} or {B}.
Initial Programming
2.5 Date and time
You must set the date and time.
1 Press {Menu}.
SYSTEM SETUP
PRESS [()]
2 Press {#}, then {0}{1}.
SET DATE & TIME
PRESS SET
3 Press {Set}.
L The cursor (|) will appear on the display.
D:|01/M:01/Y:09
TIME: 00:00
4 Enter the current date/month/year by selecting 2
digits for each.
Example: 10 August, 2009
Press {1}{0} {0}{8} {0}{9}.
D:10/M:08/Y:09
TIME: |00:00
5 Enter the current hour/minute by selecting 2 digits for
each. Press {*} repeatedly to select “AM” or “PM”,
or 24-hour time entry.
Example: 3:15PM (12 hour clock entry)
1. Press {0}{3} {1}{5}.
D:|10/M:08/Y:09
TIME: 03:15
2. Press {*} repeatedly to display “PM”.
D:|10/M:08/Y:09
TIME: 03:15PM
6 Press {Set}.
SETUP ITEM [ ]
7 Press {Menu} to exit.
{A}{B}{Set}
{
Set}
{<}{>}
{Menu}
FL323HK-PNQX2241ZA-OI-en.book Page 20 Thursday, August 6, 2009 10:12 AM
To Next Page
Loading...
