Panasonic KX-FP200 - Setting the Dialing Mode; Changing the Logo Print Position

1 2 3
4 5 6
7 8 9
0
1 2 3
4 5 6
7 8 9
0
46
Changing the logo print position
The logo, telephone number, date, time and page number will be printed on the transmitted document from
your unit in the following manner.
OUT: Outside of the transmitted document’s paper size (pre-selected setting).
IN: Inside of the transmitted document’s paper size.
1
Press (MENU).
Display:
2
Press K, then B A.
3
Press (START/COPY/SET).
4
Press or to select the desired setting.
5
Press (START/COPY/SET).
6
Press (MENU).
MODE=OUT [Ÿÿ]
LOGO POSITION
SYSTEM SET UP
(MENU)
(START/COPY/SET)
Dial keypad
Setting the dialing mode
The unit will automatically set the dialing mode to TONE or PULSE when the unit is turned on if this feature is
set to AUTO.
If you cannot dial, change the dialing mode setting to TONE or PULSE by following the instructions below.
1
Press (MENU).
Display:
2
Press K, then A C.
3
Press (START/COPY/SET).
4
Press or to select the desired setting.
5
Press (START/COPY/SET).
6
Press (MENU).
MODE=AUTO [Ÿÿ]
DIALING MODE
SYSTEM SET UP
(START/COPY/SET)
(MENU)
Dial keypad
Note:
¡If you change the dialing mode setting to TONE or PULSE, set the dialing mode again when you change the
line service.