EasyManua.ls Logo

Panasonic KX-FP205

Panasonic KX-FP205
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8. Help
47
8.3.2 General
The unit does not ring. L The ringer volume is turned OFF. Adjust it (page 16).
Problem Cause & Solution
The unit displays “PAPER
JAMMED” even though paper
is installed.
L You forced the recording paper into the paper tray too strongly. Remove all
of the installed paper, and re-install it gently.
The unit displays “CHECK
PAPER” even though paper is
inserted.
L The paper is inserted halfway. Insert it correctly (page 53) and press {SET}
to clear the message.
The other party complains
they only hear a fax tone and
cannot talk.
L FAX ONLY mode is set. Tell the other party the number is only used for
faxes.
L Change the receiving mode:
KX-FP205: TEL mode (page 26) or TEL/FAX mode (page 27)
KX-FP215: TAM/FAX mode (page 28), TEL mode (page 26) or TEL/FAX
mode (page 27)
{REDIAL} or {PAUSE} does
not function properly.
L If this button is pressed during dialling, a pause will be inserted. If pressed
immediately after a dial tone is obtained, the last number dialled will be
redialled.
The ink film runs out quickly. L Even if there are only a few sentences, every page that comes out of the
machine is considered a full page.
L Turn OFF the following features:
sending report: feature #04 on page 37.
journal report: feature #22 on page 39.
Caller ID list: feature #26 on page 39.
During programming, I
cannot enter the code or ID
number.
L All or part of the numbers are the same as another code or ID. Change the
number:
remote operation ID: feature #11 on page 38.
fax activation code: feature #41 on page 40.
auto disconnection: feature #49 on page 41.
The unit beeps. L The memory reception alert of feature #44 is ON (page 41), and the unit has
a document in memory. Press {STOP} to stop the beeps, then see the
displayed message instructions to solve the problem.
The speakerphone is not
working.
L Use the speakerphone in a quiet room.
L If you have difficulty hearing the other party, adjust the volume.
The unit does not display the
caller’s name and/or
telephone number.
L You need to subscribe to a Caller ID service.
L Other telephone equipment may be interfering with your phone. Disconnect
it and try again.
L Other electrical appliances connected to the same outlet may be interfering
with the Caller ID information.
L Telephone line noise may be affecting the Caller ID information.
L The caller requested not to send his/her information (page 20).
The display exits the Caller ID
list while viewing caller
information.
L Do not pause for over 3 minutes while viewing.
Problem Cause & Solution
FP205-215E-PFQX2485ZA-en.book Page 47 Wednesday, April 26, 2006 6:34 PM

Table of Contents

Related product manuals