1. Introduction and Installation
12
Installation
1.6 Ink film
The included film roll is a starter ink film.
1 Open the front cover.
2 Release the back cover by pushing the green button
(1).
3 Open the back cover.
4 Insert the blue gear of the ink film roll into the front
left slot of the unit (2) and the white gear of the ink
film roll into the rear left slot of the unit (3).
L The ink film is safe to touch and will not rub off on
your hands like carbon paper.
L Make sure the blue gear (2) and white gear (3)
are installed as shown.
5 Turn the blue gear (4) in the direction of the arrow
until the ink film is tight (5) and at least one layer of
ink film is wrapped around the blue core (6).
1
3
2
4
5
FP205-215E-PFQX2485ZA-en.book Page 12 Wednesday, April 26, 2006 6:34 PM
To Next Page
Loading...
