55
Fax/Copy
Signaling your pager when your unit receives
a fax
This feature allows your unit to call your pager when your unit receives a fax document.
Note:
●
If this feature does not work properly, enter more than
one pause by pressing at the end
of your pager number to extend the paging time.
●
If you wish to display a message on your pager, enter
your pager number, pause(s) and the message.
●
Message programming methods may vary depending
on the pager company. Contact your pager company
for details.
1
Press .
Display:
2
Press , then .
3
Press .
4
Press or to select “ON”.
●
If this feature is not required, select “OFF”.
5
Press .
6
Enter your pager number.
●
You can enter a total of 46 digits and/or pauses.
Example:
7
Press .
8
Press .
To Next Page
Loading...
