5. Fax
30
7 Program items.
Using stations 2–11:
Press the desired station key.
Using stations 12–22:
Press {LOWER}, then press the desired
station key.
Using navigator directory:
Press {A} or {B} repeatedly to display the
desired item and press {SET}.
L To program other items, repeat this step
(up to 10 items).
8 Press {SET}.
Note:
L If you program the wrong item, press {STOP}
after step 7 to erase the item.
L If you edit a stored item (page 19) in the
broadcast memory, the programmed
broadcast function will be cancelled. You
must re-program.
5.4.2 Sending the same
document to pre-programmed
parties
1 Insert the document FACE DOWN.
2 If necessary, press {A} or {B} repeatedly to
select the desired resolution (page 27).
3 Press {BROADCAST}.
L The document will be fed into the unit and
scanned into memory. The unit will then
send the data to each party, calling each
number sequentially.
L After transmission, the stored document
will be erased from memory
automatically, and the unit will
automatically print the transmission result
(Broadcast sending report).
Note:
L If you select “FINE”, “SUPER FINE” or
“PHOTO” resolution, the number of pages that
the unit can send will decrease.
L If the document exceeds the memory
capacity, sending will be cancelled.
L If a party is busy or does not answer, it will be
skipped and redialled later up to 5 times.
To cancel broadcast transmission
1. Press {STOP} while “BROADCASTING” is
displayed.
L The display will show “SEND
CANCELLED?”.
2. Press {SET}.
{A}{B}
{SET}
{STOP}
{BROADCAST}
FT-901-903-907BX.book Page 30 Monday, March 29, 2004 10:03 AM
To Next Page
Loading...
