Panasonic KX-FT901BX

8. Answering Device (KX-FT907 only)
43
Remote Operation
8.4 Operating from a remote location
You can call your unit from a remote location and access the answering device.
Important:
L Program the remote operation ID beforehand (feature #11, page 47).
L Set the unit to TAD/FAX mode before going out (page 35).
L Use a touch tone telephone for remote operations.
Helpful hints:
L When you press a key, press firmly.
L Please make a copy of the following table, and carry it with you when you go out.
8.4.1 Listening to recorded
messages
1 Call your unit.
2 Enter the remote operation ID during the
TAD/FAX greeting message.
3 When there are new recorded messages
1. A long beep will sound.
2. Short beep(s) will sound up to 8 times.
L This indicates the number of new
messages.
3. New messages will be played back.
When there are no new messages
1. A long beep will sound (short beep will
not sound).
2. Wait for 4 seconds or press {5}.
3. All recorded messages will be played
back.
When voice memory is full
6 beeps will sound after playing back the
messages. Erase unnecessary messages.
8.4.2 Remote operations using
remote commands
{1}: repeats a message. If you press this key
within 5 seconds of the beginning of a message,
the previous message will be played.
{2}: skips a message.
{4}: plays back new messages.
{5}: plays back all messages.
8.4.3 Other remote operations
To erase a specific message
Press {*}{4} while listening to the message you
want to erase.
L A long beep and 3 short beeps will sound.
The unit will then play back the next
message.
To erase all messages
Press {*}{5} to erase all messages.
L A long beep and 3 short beeps will sound.
Answering device remote operation
1. Call your unit.
2. Enter the remote operation ID during the
TAD/FAX greeting message.
3. Enter a remote command within 10 seconds.
{6} Room monitor
{7} Re-records the greeting message
{9} Stops re-recording of the greeting
message
{*}{4} Erases a specific message
Key Remote command {*}{5} Erases all messages
{0} Skips the greeting message {8}{0} Changes to TEL mode
{1} Repeats a message {8}{1} Turns ON message transfer
{2} Skips a message {8}{2} Turns OFF message transfer
{4} New message playback {8}{3} Turns ON pager call
{5} All message playback {8}{4} Turns OFF pager call
FT-901-903-907BX.book Page 43 Monday, March 29, 2004 10:03 AM