EasyManua.ls Logo

Panasonic KX-FT901BX - Page 44

Panasonic KX-FT901BX
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8. Answering Device (KX-FT907 only)
44
To monitor the room
Press {6} to activate the units microphone and
listen to the room where the unit is located for
about 30 seconds.
L After 30 seconds, a beep will sound. To
continue monitoring, press {6} again within
10 seconds.
To record a marker message
After playing back messages, you can leave an
additional message.
1. Wait for 3 beeps indicating the end of the
remote operation.
2. Wait for 1 beep.
3. Wait about 10 seconds.
L The voice guide and/or 1 beep will be
heard.
4. Leave a message.
To re-record your greeting message
You can record a new TAD/FAX greeting
message.
1. Press {7} to start recording.
L A long beep will sound.
2. Speak clearly for up to 16 seconds.
L If you pause for over 2 seconds, 6 beeps
will sound and recording will stop. Repeat
from step 1 within 10 seconds.
3. To stop recording, press {9}.
L The new greeting message will be played.
To skip the greeting message
Press {0} during the greeting message
playback.
L The unit will skip the rest of the greeting
message.
To turn message transfer ON or OFF
You must program a transfer telephone number
beforehand (feature #60, page 50).
Press {8}{1} to turn ON the message transfer.
Press {8}{2} to turn OFF the message transfer.
L If a transfer telephone number is not
programmed, you cannot turn this feature
ON. 6 beeps will sound.
To turn pager call ON or OFF
You must program a pager number beforehand
(feature #70, page 37).
Press {8}{3} to turn ON the pager call.
Press {8}{4} to turn OFF the pager call.
L If a pager number is not programmed, you
cannot turn this feature ON. 6 beeps will
sound.
To change from TAD/FAX to TEL mode
Press {8}{0} to change the receiving mode from
TAD/FAX to TEL.
L You cannot return to TAD/FAX mode in the
same call. To return to TAD/FAX mode, see
the following.
To change from TEL to TAD/FAX mode
1. Call your unit and wait for 10 rings.
L The answering device will temporarily
answer the call.
2. Enter the remote operation ID (feature #11,
page 47) during the greeting message.
L A long beep will sound, and your unit will
switch to TAD/FAX mode.
3. Hang up the handset.
FT-901-903-907BX.book Page 44 Monday, March 29, 2004 10:03 AM

Table of Contents

Related product manuals