9. Programmable Features
50
“DARKER”: Darker contrast.
Code #60 (KX-FT907 only): Setting the
message transfer
MESSAGE TRANS.
To transfer new voice messages to another
telephone (page 45), activate this feature and
program the transfer telephone number.
1. Press {MENU}.
2. Press {#}, then {6}{0}.
3. Press {SET}.
4. Press {A} or {B} repeatedly to select “ON”.
5. Press {SET}.
6. Enter the transfer telephone number.
7. Press {SET}.
8. Press {MENU}.
Code #61 (KX-FT907 only): Checking,
recording or erasing the transfer greeting
message
TRNS-GREETING
See page 45 for details.
Code #67 (KX-FT907 only): Setting the
incoming message monitor
ICM MONITOR
To hear an incoming message (ICM) from the
speaker when the answering device is recording
the message.
“ON” (default): You can monitor the incoming
message.
“OFF”: Deactivates this feature.
Code #70: Calling your pager
(KX-FT901/KX-FT903)
FAX PAGER CALL
(KX-FT907)
PAGER CALL
See page 37 for details.
Code #76: Setting the connecting tone
CONNECTING TONE
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones;
fax tone, ring back tone and busy tone. You can
use these tones to confirm the status of the other
party’s machine.
“ON” (default): You will hear connecting tones.
“OFF”: Deactivates this feature.
Note:
L If the ring back tone continues, the other
party’s machine may not be a facsimile or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
Code #80: Resetting advanced features to
their default settings
SET DEFAULT
To reset the advanced features:
1. Press {MENU}.
2. Press {#}, then {8}{0}.
3. Press {SET}.
4. Press {A} or {B} repeatedly to select “YES”.
5. Press {SET}.
6. Press {SET} again.
7. Press {MENU}.
Note:
L The emergency telephone numbers stored in
the dial lock feature (page 25) will be saved.
FT-901-903-907BX.book Page 50 Monday, March 29, 2004 10:03 AM
To Next Page
Loading...
