5. 5.3.24 VQ Report by PUBLISH
Add the following configuration parameter.
VQREPORT_SEND_OPT_CODEC_ENABLE
Value Format
Description
Value Range
Default Value
VQREPORT_SEND_OPT_NW_CHANGE
Value Format
Description
Value Range
Default Value
6. 5.3.25 Telephone Settings
Add the following configuration parameter.
CNIP_FROM_ENABLE
Value Format
Description
Value Range
Default Value
IDLE_DISPLAY_TYPE
Value Format
Description
Value Range
Default Value
・Y: Use 'FROM' header
・N: Use 'PAI' header
N
BOOLEAN
3
INTEGER
Specifies what is shown on the display in standby mode.
・0:Off
・1:Phone Number
・2:Phone Number&Name
・3:Name
Note
"Name" is the display name for the line.
N
INTEGER
Specifies the number of consecutive times the MOS (Mean Opinion Score) value
may fall below the threshold value specified by either
ALERT_REPORT_MOSQ_CRITICAL or ALERT_REPORT_MOSQ_WARNING
before the phone sends VQREPORT.
The ALERT_REPORT_TRIGGER setting determines whether
ALERT_REPORT_MOSQ_CRITICAL or ALERT_REPORT_MOSQ_WARNING is
used as the threshold.
0–5
(The number of consecutive times. 0:Disable)
Note
If "2" is specified and the MOS value falls within the threshold 2 consecutive
times, VQREPORT is sent.
0
Specifies whether to use the 'FROM' header or the 'PAI' header in CNIP (Calling
Number Identification Presentation).
BOOLEAN
Specifies whether to enable the sending of VQREPORT (SIP-PUBLISH) when
the codec is changed.
・Y: Send VQREPORT when a change of codec is detected
・N: Send VQREPORT at the end of a conversation
To Next Page
Loading...
