Upgrade Process
This diagram illustrates the upgrade process. This process takes approximately 10-15 minutes to complete.
Please be careful not to disconnect power
and network during firmware update.
Upgrade Firmware via WebUI
At firmware version 1.04x or earlier, you can NOT use
macros: {MAC}, {mac}, {MODEL}, {fwver}
GET “HDV130-06.00_US.fw.part1”
GET “HDV130-06.00_US.fw.part2”
When update fails by disconnect power or network,
reconnect power and network. Then device starts
update again. Do not reset to factory default.
HDV130-06.000_US.fw.part1
HDV130-06.000_US.fw.part2
To Next Page
Loading...
