14
Queues can be enabled or disabled; for set-up see administration portal manual)
Log into an existing queue directly via the telephone.Simply use to select the desired queue and
press [ENTER] to confirm. To log out of the queue, select the respective queue again and press
[ENTER] to confirm.An “x” before a queue indicates you are already logged in.
2.2. Function keys & codes
On the administration portal you can assign the following functions to any function key:
Telephone number
Busy Field Light (BFL)
Intercom
Function code
Services
Please refer to the administration portal manual for detailed information.
Telephone number
You can program any telephone number to one of your function keys. Pressing the programmed
function key then starts a telephone call.
Busy Field Light (BFL)
You can program any extension to one of your function keys. Pressing the programmed function key
starts a telephone call.
A flashing LED for the respective function key indicates an incoming call to the extension. To pick up
the call, simply press the flashing function key. In order to pick up calls, all parties must be
members of a pick-up group.You have now picked up the call.
If the monitored extension (Busy Field Light (BFL)) is busy, the LED for the respective function key
remains lit.
Program field keys freely programmable as function keys
As you can see on the telephone (KX-UT133 and KX-UT136 only) the function keys start at 1 (1 to
24).To configure the telephone’s function key 1 via the service site, please select number “0”.For
function key 2, please select number “1”, etc.
On KX-UT133 and KX-UT136 only 23 of the 24 function keys can be used. The last
function key is reserved as line key.
To Next Page
Loading...
