9
- Press the key to accept the call.
- You can now toggle the calls by directly pressing the key. The active call is shown in the
telephone display.
To end a call, simply hang up the receiver during the active call.
1.8. Conference calls/Toggle calls
Your Panasonic system telephone allows you to place a 3-way call.
- Call party 1.
- Once party 1 has been reached, press the key. The active call is now placed on
“Hold”.
- Now call party 2 and wait until party 2 has been reached.
- Now press the key to activate the 3-way call. The display now indicates
Conference.
Removing a party from a conference call / toggling
- Press during a conference call.
⇒ Party 2 is placed on hold but you may continue speaking with party 1.
- To switch between the two parties (toggle), press the key.
- To end one of the calls, simply hang up while the call with this party is active.
⇒ The party is now disconnected.
- Press the key. You can now continue the call with party 2.
A conference call with more than 3 parties can easily be set up on the administration
portal: Please refer to the administration portal manual.
Toggle refers to switching between 2 different telephone calls. Toggle places one of the
parties on hold and they then hear the telephone system’s hold music while you continue
speaking to the other party.
1.9. Attended call transfer
In order to perform an attended call transfer follow the steps below:
- During an active call press the [Transfer/ ] key.
To Next Page
Loading...
