Panasonic KX-HDV340 - 1.10. Unattended call transfer; 1.11. Call forwarding

10
- Now dial the party to whom you would like to transfer the call.
- To do so, enter the party’s telephone number and press [ENTER] to confirm.
- Wait for the other party to answer, then announce the call. If necessary, this step can also be
omitted.
- Press the softkey .
In case the other party declines the call ot does not answer, double press [CANCEL] to get back to
your caller.
1.10. Unattended call transfer
In order to perform an unattended call transfer follow the steps below:
- During an active call press the BLIND softkey.
- Now dial the party to which you would like to transfer the call.
- To do so, enter the party’s telephone number and press [ENTER] to confirm.
- Hang up the receiver.
1.11. Call forwarding
You can configure various call forwarding scenarios. For this purpose you can use the call
forwarding profiles.
Under the telephone menu you can only edit the default profle (catch all / always) to be found under
the call forwarding profiles. You can edit the remaining call forwarding profiles via Ncontrol or via
the administration portal. For more information, refer to the administration portal manual and the
Ncontrol manual.
The following call forwarding options are available. You can activate or deactivate call forwardings
via the telephone menu's call settings.
Permanent call forwarding (always)
All incoming calls will be forwarded directly to the predefined telephone number.
Forward if busy (busy)
New calls will be forwarded immediately, when coming in during an active call. This call forwarding
option functions only, if the Call Waiting function is deactivated.