308
KX-MB2230JT/ KX-MB2270JT/ KX-MB2515JT/ KX-MB2545JT/ KX-MB2575JT/ DP-MB310JT
15.1.2.1. Maintenance List
15.1.2.2. Maintenance Cycle (Document & Paper)
If each part has got dirty, clean it with a damp cloth then dry thoroughly.
* These values are standard and may vary depending on usage conditions.
NO. OPERATION CHECK REMARKS
1 Document Path Remove any foreign matter such as paper. —
2 Rollers If the roller is dirty, clean it with a damp cloth then dry thor-
oughly.
Refer to Maintenance Check Items/Com-
ponent Locations (P.307).
3 Sensors Pick up & Registration & Manual paper sensor (IC51), Print tim-
ing sensor (IC50), Toner sensor (IC53), Exit sensor (IC52),
confirm the operation of the sensors.
See Maintenance Check Items/Compo-
nent Locations (P.307) and Sensors and
Switches Section (P.66) Test Functions
(P.124).
4 Glass If the glass is dirty, clean them with a dry soft cloth. Refer to Maintenance (P.309).
5 Abnormal, wear and tear
or loose parts
Replace the part. Check if the screws are tight on all parts. —
No. Item Cleaning Cycle
1 Pickup Roller (Ref No.120) ------------
2 Transfer Roller (Ref.No.140) ------------
3 Registration Roller (Ref.No.149) 3 months
4 Heat Roller (Ref.No.75) ------------
5 Exit Roller (Ref.No.88) 3 months
To Next Page
Loading...
