Panasonic KX-NS0154

20
KX-NS0154
11.1.1.3. PC Setting
Preparation:
• PC
• Base Unit / Handset
1. Install the TeraTerm
Install the "teraterm-x.xx.exe" (x.xx = version) to your PC from internet site. Refer to the "readme" of the TeraTerm for installation
process etc.
2. Setting the TeraTerm
Before setting the TeraTarm:
USB ports 3 to 16 are available but Teraterm (version 2.3) sets to use only the USB ports 3 and 4 by default.
In case that the port number now you investigated is 5 or more.
- Open "TERATERM.INI" in installed folder.
Ex) c:\Program Files\teraterm
- Search the word "MaxComPort".
- Change the number to your port number.
Ex) If your port number is 6, then Change to "MaxComPort=6".
- Then save and quit.
2-1. Teraterm will be activated automatically if connect a PC and the base unit by a USB cable. Please restart Teraterm after
USB cable is reconnected.
2-2. Select "Serial port" from "Setup" menu.
• Change the settings of "Serial port setup" as follows. Then click OK.
(1) Select "Serial port" from "Setup" menu.
(2) Select your port number.
(Refer to " 3-1.Confirm the
USB port number")
(3) Set these items like this.
(4) Click "OK".