d. Pass the cord through the groove of the unit in one of the following three ways.
To AC Adaptor
To AC
Adaptor
To AC Adaptor
2. Connecting the Unit to the Network
Temporarily install the unit in the best site as defined in Site Planning, connect the unit to a nearby hub.
[LAN Synchronization only]
LAN synchronization
should be diagnosed in advance when connecting to a network that does not comply
with recommendations 1 and 2 in "5.3 Recommended Network Configuration".
For details about LAN synchronization diagnosis, refer to "5.4 LAN Synchronization Diagnosis".
20 Installation Guide
3 Deployment Procedure
To Previous Page
Loading...
