Useful Information
37
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Initial settings
Problem Cause & solution
w is flashing. L The handset is not registered to the base unit.
Register it (page 30).
L The handset is too far from the base unit. Move
closer.
L The AC adaptor is not connected. Check the
connections.
The handset display is blank. L The handset is not turned on. Turn the power on
(page 9).
The handset will not turn on. L Make sure that the batteries are installed correctly
(page 8).
L Fully charge the batteries (page 8).
L Clean the charge contact and charge again (page
8).
TCD200FX(e-e).book Page 37 Monday, February 7, 2005 1:19 PM
To Next Page
Loading...
