Panasonic KX-TCD220SLT

4 BATTERY
4.1. Battery Installation
1. Insert the batteries negative ( ) terminal first.
2. Close the handset cover.
Note:
· Use only rechargeable Ni-MH batteries P03P (HHR-4EPT).
4.2. Battery Charge
Place the handset on the base unit for about 7 hours before initial use.
When charging, the battery icon is shown as follows. When the batteries are fully charged,
remains on the display.
Note:
· It is normal for the handset to feel warm during charging.
· It takes 7 hours to fully charge the batteries, however, you can use the handset before the batteries are fully charged.
· Clean the charge contacts of the handset and base unit with a soft, dry cloth, otherwise the batteries may not charge
properly. Clean if the unit is exposed to grease, dust or high humidity.
· When
flashes, recharge the handset batteries. will continue to flash until the batteries have been charged for at
least 15 minutes.
· If the handset is turned off, it will be turned on automatically when it is placed on the base unit.
6
KX-TCD220SLT / KX-TCA122EXT / KX-TCA121EXT