Panasonic KX-TCD450 Series

6.11. Selecting the Display Language
· To exit the operation, press any time.
· *1 You can select one of 24 languages. If you set a language you cannot read, reset the handset to its initial settings.
Press MENU → DOWN → RIGHT → UP → RIGHT → 4-digit Handset PIN → UP → OK
All handset setting will be reset to their initial settings, however, the Phonebook data will be saved.
6.12. Select Dialling Mode (Tone/Pulse)
You can change the dialling mode to tone or pulse depending upon your network service. If you have a touch tone service,
select tone. If you have rotary or pulse service, select pulse.
· To exit the operation, press any time.
· *1: The factory preset is 0000.
6.13. Select Flash Timing
You can select the flash timing, 100 msec (milli seconds), 700 msec, or 200 msec depending on your PBX requirements.
· To exit the operation, press any time.
· *1: The factory preset is 0000.
For Service Hint: Refer to Select Flash Timing (P.17)
17
KX-TCD450RUM / KX-A145RUM / KX-TCD450RUT / KX-A145RUT