1.2.1.1. Main
(Component View)
(Flow Solder Side View)
1.2.1.2. Operation
(Component View)
(Flow Solder Side View)
Note:
The location of the “PbF“ mark is subject to change without notice.
1.2.2. Cordless Handset PCB
(Component View)
(Flow Solder Side View)
Note:
The location of the “PbF“ mark is subject to change without notice.
1.2.3. Charger Unit PCB
Note:
The location of the “PbF“ mark is subject to change without notice.
2. FOR SERVICE TECHNICIANS
ICs and LSIs are vulnerable to static electricity.
When repairing, the following precautions will help prevent recurring malfunctions.
1. Cover the plastic parts boxes with aluminum foil.
2. Ground the soldering irons.
3. Use a conductive mat on the worktable.
4. Do not touch IC or LSI pins with bare fingers.
3. CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type recommendenced by the manufacturer.
Dispose of used batteries according to the manufacture’s Instructions.
4. BATTERY
4
To Next Page
Loading...
