11.2.1. Connections
11.2.2. PC Setting
1. Open a window of MS-DOS mode from the start-up menu.
2. Change a directory.
3. Type “SET_COM 1” from the keyboard (when COM port 1 is used
for the connection).
4. Type “doskey”.
Note:
See the table below for frequently used commands.
Command name Function Example
rdeeprom Read the data of EEPROM Type “rdeeprom 00 00 FF”, and the data
from address “00 00” to “FF” is read out.
readid Read ID (RFPI) Type “readid”, and the registered ID is
read out.
writeid Write ID (RFPI) Type “writeid 00 18 E0 0E 98”, and the
ID “0018 E0 0E 98” is written.
setfreq adjust Frequency of RFIC Type “setfreq nn”.
hookoff off-hook mode on Base Type “sethooksw 01”.
hookon on-hook mode on Base Type “sethooksw 00”.
Getchk Read checksum Type “getchk”.
Wreeprom write eeprom Type "wreeprom 01 23 45". "01 23" is
address and "45" is data to be written.
For Service Hint:
Please make sure the speed of comport is “9600bps“ or less.
12. CHECK PROCEDURE (CORDLESS HANDSET)
54
To Next Page
Loading...
