AddressInitial
Type
Name Description Default
84 1
EEP_RuClipDelayBeforeReq
Delay before Send REQ signal
Unit : 10ms, Default : 200ms
0x14
85 1
EEP_RuRcvDigitBeforeReq
Receive Digit Before REQ
Default : 2digit
0x02
86 1
EEP_PseudoBellLength
Pseudo Bell Length
Unit : 10ms, Default : 800ms
0x50
87 1
EEP_PseudoBellInterdigitTimeout
Pseudo Bell Interdigit Timeout
Unit : 100ms, Default : 3200ms
0x20
88 1
EEP_PseudoBellEndTimeout
Pseudo Bell End Timeout
Unit : 1s, Default : 30s
0x1E
89 1 EEP_RuClipReqLev RCID REQ signal Level
Default : -4.3dBm
0x00, 0x19
272 2 EEP_RuClipOnOff Russian CLIP On/Off 0x01
273 2
EEP_RuClipRingNumBeforeSequence
Number Of Rings Patterns Before Start
Sequence
Default : 1
0x01
274 2
EEP_RuClipDisplayDigit
Number Of digits to be displayed
Default:7 digits
0x07
28. EEPROM LAYOUT (CORDLESS HANDSET)
28.1. Scope
The purpose of this section is to describe “layout of the EEPROM (IC10) KX-TCA151 Cordless
Handset”.
The EEPROM contains hardware, software, and user specific parameters. Some parameters are
set during production of the cordless handset e.g. crystal oscillator adjustment at 0057, some
are set by the user when configuring the cordless handset e.g. ringer volume at 00A1, and some
during normal use of the phone e.g. redial memory at 1EF6..1F77.
28.2. Introduction
The handset uses a 64k bit serial EEPROM (IC10) for storing volatile parameters. All parameters
are set up before the cordless handset the factory. Some of these are vital for the operation of
the hardware so a set of default parameters is programmed before the actual hardware fine-
tuning can be initiated. This document lists all default settings with a short description.
This document lists all default parameters with a short description.
In the tables below values in a range that are similar are not repeated; i.e. Address 00 to 01
contains the value 00 simply means that the value 00 is repeated in all addresses in the range.
98
To Next Page
Loading...
