4.6 CO Line Programming
Host PBX Access Codes
4-90 System Programming
411
Description
Assigns Host PBX access codes. If the system is installed behind a
host PBX system, an access code is required to make an outside
call. Up to four codes can be stored for a CO line group assigned
the line.
Selection
• CO line group (TRG) number: 1 through 8,
( =all CO line groups)
• Access code: 1 or 2 digits, four different entries (max.)
Default All CO line groups – Not stored
Programming 1. Enter 411.
Display : TRG Host PBX NO.
2. Press NEXT.
Display : TRK GRP NO?–>
3. Enter a CO line group number.
To enter CO line group number 1, you can also press NEXT.
Display example: TRG1: , , ,
4. Enter an access code.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and the new access code.
Display example: TRG1:01, , ,
5. To enter more access codes for the same CO line group, press
and enter the access codes until all the required entries
are completed.
Display example: TRG1:01,08,10,22
6. Press STORE.
7. To program another CO line group, press NEXT or PREV, or
SELECT and the desired CO line group number.
8. Repeat steps 4 through 7.
9. Press END.
To Next Page
Loading...
Need help?
General
