Panasonic KX-TDE100 - Page 86

Basic Setting
Parameter Description
Location
*1
Specifies the location where the KX-HGT100 is installed.
Language Specifies the language to be displayed on the LCD.
Telephone Number
*3
Specifies the extension number of the KX-HGT100.
SIP ID
*3
Specifies the extension number of the KX-HGT100.
SIP Password
*3
Specifies the password for the KX-HGT100.
Proxy Address
*3
Specifies the IP address of the IPCMPR/IPCEMPR card.
Proxy Port
*3
Specifies the port number associated with the IP address entered in Proxy
Address.
Registrar Address
*3
Specifies the IP address of the IPCMPR/IPCEMPR card.
Registrar Port
*3
Specifies the port number associated with the IP address entered in Registrar
Address.
SIP Domain
*3
Specifies the IP address of the IPCMPR/IPCEMPR card.
Register Expire Specifies the length of time (1–4294967295 seconds) that the KX-HGT100
sends the REGISTER message to the PBX.
*2
Session Expire Specifies the length of time (60–65535 seconds) after which the KX-HGT100
terminates SIP sessions when no communication is detected.
*1
This parameter is not available with
KX-HGT100C.
*2
This setting will be overwritten by the
SIP Location Hold Time Max. setting of the PBX. For details, refer to "3.17 [1-1] Slot—Card
Property - Virtual SIP Extension" in the PC Programming Manual.
*3
These parameters can also be programmed by the KX-HGT100. For details about the procedure for the KX-HGT100, refer to "Basic
Setting programming through the KX-HGT100".
86 IP Networking Guide
4.4.1 Registering IP Telephones