Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333 7
Preparation
Battery charge
Place the handset on the base unit or
charger for about 7 hours before initial
use.
Battery strength
Panasonic Ni-MH battery performance
Note:
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L Even after the handset is fully charged,
the handset can be left on the base unit or
charger without any ill effect on the
batteries.
L The battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit or charger and charge for at least 7
hours.
Controls
Handset
A Receiver
B Display
C {k} (Phonebook)
D {C} (Talk)
E Navigator ({e}/{v}/{>}/{<})
F {R} (Redial/Pause)
G {R} (Recall)
H Charge contacts
I Microphone
J {j/OK} (Menu/OK)
K {ih} (Off/Power)
L {C} (Clear)
M {INT} (Intercom)
N Ringer
Base unit
A Charge contacts
B {x} (Page)
Battery icon Battery strength
054 Fully charged.
5 High
6 Medium
7 Low
074 Needs to be charged.
Operation Operating time
In continuous use 10 hours max.
In continuous standby
mode
120 hours max.
C
R
IN
T
3
2
1
4
7
6
5
8
0
9
B
C
L
M
H
K
D
A
E
F
G
I
J
H
N
LINE
B
A
TG1100_1102_1103E(e).book Page 7 Wednesday, May 31, 2006 5:51 PM
To Next Page
Loading...
