38
KX-TG1711MEB/KX-TG1712MEB/KX-TGA171MEB
11.4. The Setting Method of JIG (Handset)
11.4.1. Preparation
11.4.1.1. Equipment Required
• DECT tester: Rohde & Schwarz, CMD 60 is recommended.
• Frequency counter: it must be precise to be able to measure 1Hz (precision; ± 4ppm).
Hewlett Packard, 53131A is recommended.
• DC power: it must be able to output at least 1A current under 2.4V for Handset.
• Digital multi-meter (DMM): it must be able to measure voltage and current.
• Oscilloscope
11.4.1.2. JIG and PC
• Serial JIG
PQZZT1CD300E*
• PC which runs in DOS mode.
• Batch file CD-ROM for setting: PNZZTG1711ME
Note:
*: If you have the JIG Cable for TCD500 series
(PQZZ1CD505E), change the following values of
resistance. Then you can use it as a JIG Cable for both
TCD300 and TCD500 series. (It is an upper compatible JIG
Cable.)
11.4.2. PC Setting
11.4.2.1. Connections
Connect the DC Power or Battery to BATTERY(+) and BATTERY(-) (Handset).
Serial JIG to the Serial Port of PC.
Connect the Clip cable GND.
Connect the Clip cable TXD and RXD.
Note:
*: Comport names may vary depending on what your PC calls it.
Resistor Old value (kΩ)New value (kΩ)
R2 22 3.3
R3 22 3.3
R4 22 4.7
R7 4.7 10
GND
(black)
3
To Serial Port
(com port 1*)
PC
(yellow)
4
TXD
4
RXD
(red)
Handset P. C. board
GND
TXDRXD
DC Power
or Battery
BATTERY
1
BATTERY
-
+
VBAT
2
To Next Page
Loading...
