43
KX-TG1711MEB/KX-TG1712MEB/KX-TGA171MEB
11.8. How to Check the Handset Speaker or Receiver
1. Prepare the digital voltmeter, and set the selector knob to ohm meter.
2. Put the probes at the speaker terminals as shown below.
11.9. Frequency Table (MHz)
Ch. (hex) TX/RX Frequency (MHz)
Channel 0 00 1928.448
Channel 1 01 1926.720
Channel 2 02 1924.992
Channel 3 03 1923.264
Channel 4 04 1921.536
Is the value between
(+) terminal and (–) terminal about 150Ω?
NG
NO
OK
YES
Replace the new
speaker.
Handset speaker
Digital Voltmeter
To Next Page
Loading...
