Panasonic KX-TG2238S - Listening to Voice Mail Messages

Voice Mail Service
38
Listening to Voice Mail Messages
After the voice mail box has received messages, the unit will indicate it in two ways:
(a) “ Voice Mail ” will be displayed on the handset, and (b) the VM indicator on the
base unit will flash.
To listen to your voice mail message(s)
• You can also listen to your voice mail message(s) by using [] or [] .
1. Press [] or [] .
2. Press VM within 15 seconds.
• After 15 seconds, “ VM ” will disappear and “ (VE) ” will
be displayed.
• If a voice mail access number is not stored, “ VM ” will not be displayed. To
store the number, see page 36.
3. Follow steps 3 and 4 of “To listen to your voice mail message(s)” above.
• If “ Voice Mail ” still remains on the display and the VM indicator still flashes even
if you have listened to your voice mail message(s), press and hold [OFF] until the
unit beeps. “ Voice Mail ” will disappear and the VM indicator will go out.
• If your voice mail service uses a voice mail tone and the recorded message is
over 3 minutes long, “ Voice Mail ” may not be displayed and the VM indicator
may not flash.
• If your voice mail service uses a voice mail tone, the tone will be heard from any
parallel connected phone. If you use another phone to retrieve messages, you
have to dial your access number manually.
1
Press [MENU] .
2
Scroll to “ V.M. access ” by pressing [] or
[] , then press Select .
• The unit is connected to the telephone line and
dials the access number (p. 36) in speakerphone
mode.
• If the handset beeps 3 times and “ Store VM
access# ” is displayed, a voice mail access
number is not stored. To store the number, see
page 36.
3
Follow the pre-recorded instructions.
4
When finished, press [OFF] .
1
Press [VM] .
• The unit is connected to the telephone line and dials the access number
(p. 36) in speakerphone mode.
• If the base unit beeps 3 times, a voice mail access number is not stored. To
store the number, see page 36.
2
Follow the pre-recorded instructions.
3 When finished, press [SP-PHONE].
Handset
>
>
V.M. access
Exit Select
>
>
1234567PPP890
(VE) Hold
Example
Talk
00-00-08
VM Hold
Base Unit
✷✸✸✿✤✦✪✪✿✮❃ ✦✫  