Panasonic KX-TG283CSK

Wall mounting
The base unit can be mounted on a wall by
changing the wall mounting adaptor’s position.
Note:
R Make sure that the wall and the fixing method
are strong enough to support the weight of the
unit.
Base unit
1 To remove the wall mounting adaptor, push
down the release levers (A). Remove the
adaptor (B).
A
B
B
A
2 A Turn the adaptor so that the words “UP
WALL” are facing up.
B Tuck the telephone line cord inside the wall
mounting adaptor.
C Connect the AC adaptor cord and
telephone line cord.
1
3
2
Hook
3 Insert the lower tabs of the adaptor into the
unit’s bottom slots (A), then insert by pushing
down the levers of the adaptor into the upper
slots (B).
R The words “UP WALL” should be facing up.
A
A
B
B
4 Mount the unit on a wall then slide down to
secure in place.
Wall phone plate
102 mm
83 mm
(3
1
/
4
inches)
or
102 mm
(4 inches)
1
2
83 mm
(4 inches)
1
2
(3
1
/
4
inches)
Charger
Drive the screws (not supplied) into the wall.
25.4 mm
(1 inch)
Screws
Hooks
40
Useful Information
TG477xC(en-en)_1214_ver021.pdf 40 2011/12/14 16:37:36