Useful Information
41
For assistance, please visit http://www.panasonic.com/help
Battery recharge
Making/answering calls, intercom
Problem Cause/solution
The handset beeps and/or )
flashes.
L Battery charge is low. Fully charge the batteries (page 9).
I fully charged the batteries, but
– ) still flashes,
– 0 is displayed, or
– the operating time seems to
be shorter.
L Clean the battery ends (S, T) and the charge contacts
with a dry cloth and charge again.
L It is time to replace the batteries (page 9).
Problem Cause/solution
_ is displayed. L The handset is too far from the base unit. Move closer.
L The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
L The handset is not registered to the base unit. Register it
(page 25).
Noise is heard, sound cuts in
and out.
L You are using the handset or base unit in an area with
high electrical interference. Re-position the base unit and
use the handset away from sources of interference.
L Move closer to the base unit.
L If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
The handset does not ring. L The ringer volume is turned off. Adjust the ringer volume
(page 20).
L Silent mode is turned on. Turn it off (page 23).
The base unit does not ring. L The ringer volume is turned off. Adjust the ringer volume
(page 15).
I cannot make a call. L The dialing mode may be set incorrectly. Change the
setting (page 13).
L The handset is too far from the base unit. Move closer
and try again.
I cannot make long distance
calls.
L Make sure that you have long distance service.
TG413x(e).book Page 41 Friday, September 24, 2010 8:45 AM
To Next Page
Loading...
