Panasonic KX-TG4381AL - Page 46

Useful Information
46
Registration
Problem Cause/solution
The handset registration may
have been cancelled or the
communication between the
base unit and the handset is
unstable.
L Re-register the handset.
1 Handset: {MENU} i {#}{1}{3}{0}
2 Base unit:
KX-TG4381/KX-TG4382
Press and hold {LOCATOR} for 4
seconds. (No registration tone)
KX-TG4391/KX-TG4392/KX-TG4393/
KX-TG4394
Press and hold {LOCATOR} for 4
seconds until the registration tone
sounds.
– If all registered handsets start ringing,
press the same button to stop. Then
repeat this step. (KX-TG4382/
KX-TG4392/KX-TG4393/KX-TG4394)
– The next step should be completed
within 90 seconds.
3 Handset: Press {OK}, then wait until a
beep sounds. i {OFF}
– While registering, “Base
registering” is displayed on all
handsets. (KX-TG4382/
KX-TG4392/KX-TG4393/KX-TG4394)
If the registration fails, try to deregister the
handset.
KX-TG4381/KX-TG4391
Press {MENU} i {#}{1}{3}{1} i
{3}{3}{5} i {OK} i {1}, then re-register
it again.
KX-TG4382/KX-TG4392/KX-TG4393/
KX-TG4394
Use another handset to deregister the
unstable handset. Press {MENU} i
{#}{1}{3}{1} i {3}{3}{5} i {OK} i
{1}, {2}, {3} or {4} (The handset number
which you want to cancel). Try to re-register it
again.
L If the above remedy does not solve the
problem, consult your nearest Panasonic
service centre.
TG43xxAL(e)_OI.book Page 46 Friday, May 23, 2008 3:51 PM