Useful Information
43
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
*1 KX-TG4382/KX-TG4392
*2 KX-TG4391/KX-TG4392
Display message Cause/solution
Busy
or
System is busy.
Please try again
later.
L The called handset
*1
or base unit
*2
is in use.
L Another handset is in use and the system is busy. Try
again later.
*1
L The handset you are using is too far from the base unit.
Move closer and try again.
L The handset’s registration may have been cancelled.
Re-register the handset (page 48).
Check tel line L The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 12).
Dial locked L Dial lock is turned on. To turn it off, see page 19.
Don’t use this
battery.
L A wrong type of batteries such as Alkaline or
Manganese was inserted. Use only the rechargeable Ni-
MH batteries noted on page 5, 13.
Error!! L The handset’s registration has failed. Move the handset
and base unit away from all electrical appliances and try
again.
L The entered password was wrong in programming dial
lock. Enter the correct password.
Insert battery L The handset was placed on the base unit or charger
without batteries. Insert the batteries properly (page 13).
Invalid L There is no handset registered to the base unit matching
the handset number you entered.
L The handset is not registered to the base unit. Register
the handset (page 48).
No link to base.
Reconnect AC
adaptor.
L The handset has lost communication with the base unit.
Move closer to the base unit and try again.
L Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset’s registration may have been cancelled.
Re-register the handset (page 48).
Phonebook full L The phonebook memory is full. Erase unnecessary
entries (page 21).
Store VM access# L You have not stored the voice mail access number.
Store the number (page 37).
TG43xxNZ(e)_OI.book Page 43 Tuesday, August 26, 2008 1:58 PM
To Next Page
Loading...
