Useful Information
53
Answering system (KX-TG7321)
The SMS message centre
number is logged in the caller
list and the message is not
received.
L Someone tried to send you a message while
SMS is turned off. Turn it on (page 32).
“FD” is displayed. L The unit could not connect to the SMS
message centre. Confirm that the correct
SMS message centre numbers are stored
(page 32). Confirm that SMS is turned on
(page 32).
“FE” is displayed. L An error occurred while sending the message.
Try again.
“E0” is displayed. L Your phone number is permanently withheld
or you have not subscribed to the appropriate
service. Contact your service
provider/telephone company.
“Q” is not displayed after I read
a message.
L When an error code (“FD”, “FE”, or “E0”) is
displayed, “Q” will not be displayed even if
you have read the message.
Problem Cause/solution
The unit does not record new
messages.
L The answering system is turned off. Turn it on
(page 36).
L The message memory is full. Erase
unnecessary messages (page 38).
L The recording time is set to “Greeting
Only”. Change the setting (page 41).
L If you subscribe to the voice mail service,
messages are recorded by your service
provider/telephone company not your
telephone. Change the unit’s number of rings
setting or contact your service
provider/telephone company (page 40).
My own greeting message
cannot be properly heard.
L Record your own greeting message again
(page 37).
I cannot operate the answering
system.
L Someone is using the unit. Wait for the other
user to finish.
L A caller is leaving a message. Wait for the
caller to finish.
L The handset is too far from the base unit.
Move closer.
Problem Cause/solution
TG7301-7321FX(e).book Page 53 Wednesday, March 26, 2008 5:19 PM
To Next Page
Loading...
