151
Registering a headset to the base unit
Important:
• Make sure that the Bluetooth headset is not
connected to any other Bluetooth device.
1. Your headset:
Set your headset to registration mode.
Refer to the headset operating instructions.
2. Handset:
[MENU] [#][6][2][1]
3. Enter your headset PIN.
Typically, default PIN is “0000”. Refer to the
headset operating instructions.
4. Press [OK], then wait until a long beep sounds.
5. [OFF]
When the HEADSET indicator on the base unit
lights green, you are ready to use the headset.
Connecting/disconnecting a headset
If you cannot connect the headset and base unit
using the headset, you can connect using the unit.
To Next Page
Loading...
